Ways to Dry Your Wet Phone

There is a good chance that your cell phone can be resuscitated as long as you act fast even if a wet cell phone seems dead. The greater the likelihood it will destroy the phone for good, the longer the water sits inside. Water damage is probably not covered by your phone’s warranty so it is really a problem.  

    Your phone’s warranty probably doesn’t cover water damage even though consumers are conditioned top send back broken merchandise. Most of the today’s phones come with a water sticker that permanently changes color if it gets wet and you may not have much luck pulling a fast one on your phone company. To help you with the issue, here are some ways to dry your phone. 

    Remove the Battery 

    Remove the battery to immediately cut the power. Resist the urge to power up your phone to see if it works even though it is tempting because you can short out the circuits. You will need to remove the SIM card as well if you have a GSM phone. Information such as the contacts in your phonebook can be stored in your SIM so it must be preserved. 

    Dry Your Phone 

    You must dry your phone as fast as possible. The chance of corrosion damaging the phone’s innards increases if you let the moisture evaporate naturally. You can blow or suck the water out but never use a hair dryer because its heat can damage the inside parts of your phone. Instead, you can use an air compressor set to a low psi or a vacuum cleaner.  

    Use a Desiccant 

    To wick away any leftover moisture, use a desiccant. Uncooked rice is the most convenient way. You should just leave the phone as well at its disconnected battery submerged in a bowl of uncooked rice overnight. You can instead use the packets of silica gel that often come stuffed in the pockets of new clothes if you are worried about rice dust getting inside your phone. 

    Do not waste time shopping if you don’t already have a drawer full of silica gel because acting fast is far more important than avoiding a little dust from uncooked rice.  

    Avoiding heat is the most important thing to remember. This means that you should avoid using ovens, hairdryers, microwaves or long periods of direct sunlight. It can warp components and melt adhesives even though it will certainly evaporate the moisture trapped inside.  

    You must also avoid dunking your phone in rubbing alcohol because of the fragile glues since it can dissolve internal adhesives. You can still wipe the outside part with alcohol if you drop your phone in the toilet to disinfect it. 

    You must flush the whole thing in fresh water before it dries if your phone gets soaked in salt water because salt water leaves crystals that can damage a phone’s fragile components. You just need to be sure to remove the battery prior to flooding the device. 

    Well, if things didn’t go well after these steps, then you must consider professional help. Good thing, cell phone repair service in Edmonton offers high-quality work at an affordable price and guarantees customer satisfaction.